Circuit/System Verification
WARNING: This page is about a different variant/trim than selected.
- Verify there are no DTCs set related to the following system/component:
- B9 Ambient Air Temperature Sensor
- B14A Transmission Output Shaft Speed Sensor
- B26 Crankshaft Position Sensor
- B34 Engine Coolant Temperature Sensor
- B115 Vehicle Speed Sensor
- Exhaust Aftertreatment System
- Fuel System
- Induction System
- If a related DTC is set
- Go to next step: If a related DTC is not set
- Verify the condition does not exist:
- Aftermarket equipment/accessories: Performance Components - Installed
- Accessory drive belt component - Worn/Failed
- Fuel Contamination - Refer to: Contaminants-in-Fuel Diagnosis
- If a condition exists
Repair or replace as necessary.
- Go to next step: If no condition exists
- Operate the vehicle within the Conditions for Running the DTC. You may also operate the vehicle within the conditions that you observed from the Freeze Frame/Failure Records data.
Verify the DTC does not set.
- If the DTC sets
Refer to: Circuit/System Testing
- Go to next step: If the DTC does not set
- If the DTC sets
- All OK.