Conditions for Running the DTC
WARNING: This page is about a different variant/trim than selected.
P0231
- DTC P129E = Not set
- Engine = Cranking or Running
- Fuel Pump Enable = On - For greater than 40 s
- Ignition Voltage = Greater than 7 V
Frequency the DTC runs = Continuously - After the running conditions are met
P0232
- DTC P129E = Not set
- Fuel Pump Command = 0%
- Fuel Pump Enable = On
Frequency the DTC runs = Continuously - After the running conditions are met
P023F
- DTC P0627, P0628, P0629, P1255, P129E = Not set
- Fuel Pump Command = Greater than 37%
- Fuel Pump Enable = On
- Ignition Voltage = Greater than 11 V
Frequency the DTC runs = Continuously - After the running conditions are met