LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2019 >> Cruze Premier, 4D Hatchback >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 10 (Engine Controls And Fuel - 1.6L (LH7) Diesel - Diagnostic Information And Procedures (P0016-P054F)) >> Diagnostic Information and Procedures >> DTC P0231, P0232, or P023F >> Component Testing

Component Testing

WARNING: This page is about a different variant/trim than selected.
  1. Ignition/Vehicle & All vehicle systems - Off
  2. Disconnect the electrical connector: K111 Fuel Pump Driver Control Module
  3. Connect a DMM, set on the diode setting, between the test points:
    • Red lead @ Low Reference terminal 16
    • Black lead @ Ground terminal 9
  4. Verify the DMM displays between 0.4 and 0.8 V.
    • If not between 0.4 and 0.8 V 

      Replace the component: K111 Fuel Pump Driver Control Module

    • Go to next step: If between 0.4 and 0.8 V 
  5. Connect a DMM, set on the diode setting, between the test points:
    • Red lead @ Ground terminal 9
    • Black lead @ Low Reference terminal 16
  6. Verify the DMM displays the following: O.L.
    • If not the specified value 

      Replace the component: K111 Fuel Pump Driver Control Module

    • Go to next step: If the specified value 
  7. All OK.
scientia non olet · About LEMON Manuals