Circuit/System Verification
WARNING: This page is about a different variant/trim than selected.
- Verify there are no DTCs set related to the following system/component: Fuel Injectors
- If a related DTC is set
- Go to next step: If a related DTC is not set
- Operate the vehicle within the Conditions for Running the DTC. You may also operate the vehicle within the conditions that you observed from the Freeze Frame/Failure Records data.
- Verify the DTC does not set.
- If the DTC sets
Replace the component: K20 Engine Control Module
- Go to next step: If the DTC is not set
- If the DTC sets
- All OK.