LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2019 >> Cruze Premier, 4D Hatchback >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 10 (Engine Controls And Fuel - 1.6L (LH7) Diesel - Diagnostic Information And Procedures (P0016-P054F)) >> Diagnostic Information and Procedures >> DTC P01F0 >> Circuit/System Verification

Circuit/System Verification

WARNING: This page is about a different variant/trim than selected.
  1. Ignition ON, verify that DTC P0117, P0118, P0119, or P0128 is not set.
    • Go to next step: If DTC P0117, P0118, P0119, or P0128 is not set 
  2. Verify the cooling system is filled to the correct coolant level. Refer to Cooling System Draining and Filling , and Loss of Coolant .
    • If the coolant level is not correct 

      Repair as necessary

    • Go to next step: If the coolant level is correct 
  3. Engine running for 15 min with the A/C OFF, increase the engine speed to 3000 RPM.
  4. Verify the scan tool ECT Sensor parameter is greater than 80°C (176°F).
    • If less than 80°C (176°F) 

      Replace the Engine Coolant Thermostat.

    • Go to next step: If greater than 80°C (176°F) 
  5. Operate the vehicle within the Conditions for Running the DTC. You may also operate the vehicle within the conditions that you observed from the Freeze Frame/Failure Records data.
  6. Verify the DTC does not set.
    • If the DTC sets 

      Refer to Circuit/System Testing.

    • Go to next step: If the DTC does not set 
  7. All OK.
scientia non olet · About LEMON Manuals