Installation Procedure
WARNING: This page is about a different variant/trim than selected.
Install a NEW throttle body gasket. (2)
- Install the throttle body. (1)
- Throttle Body Bolt (3) - Install and tighten [4x] 10 N.m (89 lb in)
Connect the electrical connector. (1)
Charge Air Cooler Outlet Air Hose (1) @ Throttle Body (2) - Install
- Quick Connector Clamp (3) - Install
- When the replacement is completed, use a scan tool to perform the appropriate reset functions. Control Module References
CAUTION: