Removal Procedure
WARNING: This page is about a different variant/trim than selected.
- Disconnect the battery negative cable. Battery Negative Cable Disconnection and Connection
- Front Bumper Fascia - Remove - Front Bumper Fascia Replacement
- CAUTION:
Do not disconnect the nitrogen oxide sensor from the nitrogen oxide sensor control module. A separation of the two components may cause a defect on the nitrogen oxide sensor control module. Always replace the nitrogen oxide sensor along with the nitrogen oxide sensor control module as an assembly.
Disconnect the electrical connector. (2)
- Wiring Harness Retainer (1, 3) - Unclip [2x]
Remove the 2 nitrogen oxides sensor control module nuts (1).
- Remove the nitrogen oxides sensor control module (2).
Wiring Harness Retainer (1) - Unclip [2x]
- Lower the vehicle.
- NOTE:
Do not bend the cable sharply at the base of either the sensing unit or sensor ECU in the final mounting position
Wiring Harness Retainer (1) - Unclip [2x]
- Nitrogen Oxides Sensor (2) - Remove
- Remove the nitrogen oxides sensor assembly from the vehicle.
NOTE:
Do not bend the cable sharply at the base of either the sensing unit or sensor ECU in the final mounting position