Installation Procedure
WARNING: This page is about a different variant/trim than selected.
- WARNING:
In order to reduce the risk of fire and personal injury, before connecting fuel pipe fittings, always apply a few drops of clean engine oil to the male pipe ends.
This will ensure proper reconnection and prevent a possible fuel leak.
During normal operation, the O-rings located in the female connector will swell and may prevent proper reconnection if not lubricated.
Apply a few drops of clean engine oil to the male pipe end.
Push both sides of the fitting together in order to snap the retaining tabs into place.
Once installed, pull on both sides of the quick connect fitting to make sure the connection is secure.
Retainer @ Quick Connect Fitting - Install