Removal Procedure
WARNING: This page is about a different variant/trim than selected.
WARNING:
WARNING:
- Fuel Tank Replacement - Remove
- Fuel Return Rear Pipe Replacement - Fuel Pump Module to Underbody - Remove
- Fuel Feed Intermediate Pipe Replacement - Remove
Disconnect the electrical connector:
- Fuel Tank Fuel Pump Module (1)
- Fuel Pressure Sensor (2)
Install the CH-45722 Main Fuel Pump Locking Ring Remover/Installer (1) to the fuel pump module lock ring (2).
- Using the CH-45722 Main Fuel Pump Locking Ring Remover/Installer (1) and a long breaker-bar, rotate the lock ring in a counterclockwise direction in order to unlock the lock ring.
- Remove the CH-45722 Main Fuel Pump Locking Ring Remover/Installer (1).
- NOTE:
Lift the fuel tank fuel pump module up slightly. Pay attention to the fuel level sensor.
Remove the fuel tank pump module locking ring (1).
- Fuel Tank Fuel Pump Module (2) - Remove
- Remove and DISCARD the fuel pump module seal (3).
- Fuel Level Sensor Replacement - Remove
NOTE:
DO NOT use impact tools. Significant force will be required to release the lock ring. The use of a hammer and screwdriver is not recommended. Secure the fuel tank in order to prevent fuel tank rotation.