Installation Procedure
WARNING: This page is about a different variant/trim than selected.
- CAUTION:
Exhaust Temperature Sensor - Position 3 (1) @ Exhaust Front Pipe (2) - Install and tighten 45 N.m (33 lb ft)
Electrical Connector (3) @ Wiring Harness Bracket (2) - Install
- Connect the electrical connector. (1)
- Front Wheelhouse Liner - Right Side - Install - Front Wheelhouse Liner Replacement
- If replacing the sensor, perform the exhaust gas temperature sensor reset. Exhaust Gas Temperature Sensor Reset
- Perform the NOx catalyst reductant loading reset. NOx Catalyst Reductant Loading Reset