Installation Procedure
WARNING: This page is about a different variant/trim than selected.
- CAUTION:
Install the exhaust temperature sensor - position 2 (1) to the catalytic converter and tighten to 45 N.m (33 lb ft).
- Install the exhaust temperature sensor wiring harness to the 2 clips (3).
- Install the exhaust temperature sensor - position 2 wiring harness plug to the bracket clip.
- Connect the exhaust temperature sensor - position 2 electrical connector (2).
- Battery Negative Cable Disconnection and Connection - Connect
- If replacing the sensor, perform the exhaust gas temperature sensor reset. Exhaust Gas Temperature Sensor Reset
- Perform the NOx catalyst reductant loading reset. NOx Catalyst Reductant Loading Reset