Removal Procedure
WARNING: This page is about a different variant/trim than selected.
- Disconnect the battery negative cable. Battery Negative Cable Disconnection and Connection
- Front Wheelhouse Liner - Right Side - Remove - Front Wheelhouse Liner Replacement
- CAUTION:
Do not bend the exhaust flex pipe more than 10 degrees in any direction. Bending of more than 10 degrees or twisting in a range of ± 0.5 degrees will damage the exhaust flex decoupler.
Disconnect the electrical connector. (2)
- Wiring Harness Clip (5) - Remove [2x]
- Exhaust Particulate Sensor Fastener (1) - Remove [2x]
- Remove the exhaust particulate sensor control module (3) from the bracket (4).
Wiring Harness Clip (1) - Remove
- NOTE:
Do NOT bend the cable sharply at the base of either the sensing unit or sensor ECU in the final mounting position.
Exhaust Particulate Sensor (1) - Remove
NOTE:
Secure the exhaust particulate sensor control module from falling down in order to prevent a defect on the control module.