Installation Procedure
WARNING: This page is about a different variant/trim than selected.
Install a NEW EGR valve seat gasket (1) into the EGR cooler housing (5).
- Install a NEW EGR valve gasket (2).
- Install the EGR valve (3) to the EGR cooler housing (5).
- Install the 2 EGR valve bolts (4) and tighten to 10 N.m (89 lb in).
Connect the EGR valve wiring harness plug (2) to the EGR valve (1).
- Install the throttle body assembly. Refer to Throttle Body Assembly Replacement .
CAUTION:
Refer to Fastener Caution .