Removal Procedure
WARNING: This page is about a different variant/trim than selected.
- Battery Negative Cable Disconnection and Connection - Disconnect
Remove the electrical connector (1) from the exhaust gas recirculation vacuum regulator solenoid valve (2).
- Remove the charge air bypass regulator solenoid valve inlet tube (4) from the exhaust gas recirculation vacuum regulator solenoid valve (2).
- Remove the exhaust gas recirculation vacuum regulator valve hose (5).
- Remove the 2 exhaust gas recirculation vacuum regulator solenoid valve bolts (3).
- Remove the exhaust gas recirculation vacuum regulator solenoid valve (2).