Removal Procedure
WARNING: This page is about a different variant/trim than selected.
- Remove the air cleaner outlet duct. Air Cleaner Outlet Duct Replacement
Exhaust Gas Recirculation Cooler Temperature Sensor - Position 1 (2) @ Exhaust Manifold (3) - Remove
- Raise and support the vehicle. Lifting and Jacking the Vehicle
- Front Bumper Fascia Extension - Remove - Front Bumper Fascia Extension Replacement (without Front Bumper Shutter)Front Bumper Fascia Extension Replacement (with Front Bumper Shutter)
Exhaust Gas Recirculation Cooler Temperature Sensor Electrical Connector (2) - Disconnect
- Electrical Connector (1) @ Wiring Harness Clip (3) - Unclip
- Wiring Harness Clip (4) - Unclip
- Lower the vehicle.
Exhaust Gas Recirculation Cooler Temperature Sensor - Position 1 (2) - Remove