Removal Procedure
WARNING: This page is about a different variant/trim than selected.
Disconnect the electrical connector. (1)
- Exhaust Gas Recirculation Cooler Temperature Sensor (2) - Remove
Exhaust Gas Recirculation Cooler Outlet Pipe Bolt (1) @ Intake Manifold - Remove [2x]
- Exhaust Gas Recirculation Cooler Outlet Pipe Bolt (4) @ Exhaust Gas Recirculation Cooler - Remove [2x]
- Exhaust Gas Recirculation Cooler Outlet Pipe (5) - Remove
- Exhaust Gas Recirculation Cooler Outlet Pipe Gasket (3) - Remove and DISCARD
- Exhaust Gas Recirculation Cooler Outlet Pipe Seal (2) - Remove and DISCARD