Installation Procedure

WARNING: This page is about a different variant/trim than selected.

Courtesy of GENERAL MOTORS COMPANY

Exhaust Gas Recirculation Cooler Outlet Pipe Seal (2) - Install NEW
Exhaust Gas Recirculation Cooler Outlet Pipe Gasket (3) - Install NEW
Exhaust Gas Recirculation Cooler Outlet Pipe (5) - Install

CAUTION:

Exhaust Gas Recirculation Cooler Outlet Pipe Bolt (4) @ Exhaust Gas Recirculation Cooler - Install and tighten [2x] 10 N.m (89 lb in)
Exhaust Gas Recirculation Cooler Outlet Pipe Bolt (1) @ Intake Manifold - Install and tighten [2x] 10 N.m (89 lb in)
Courtesy of GENERAL MOTORS COMPANY

NOTE:
The guide lug (1) must fit the groove.

Exhaust Gas Recirculation Cooler Temperature Sensor (2) - Install and tighten 45 N.m (33 lb ft)
Connect the electrical connector. (1)