Installation Procedure

WARNING: This page is about a different variant/trim than selected.

Courtesy of GENERAL MOTORS COMPANY

Engine Control Module and Electronic Brake Control Module Bracket (1) - Install

CAUTION:

Engine Control Module and Electronic Brake Control Module Bracket Bolt (3) - Install and tighten [2x] 12 N.m (106 lb in)
Engine Wiring Harness Bracket (2) @ Engine Control Module and Electronic Brake Control Module Bracket (1) - Install
Courtesy of GENERAL MOTORS COMPANY

Wiring Harness Clip (2, 3) @ Engine Control Module and Electronic Brake Control Module Bracket (1) - Install [4x]
Engine Control Module Bracket - Install - Engine Control Module Bracket Replacement
{If equipped} Transmission Control Module - Install - Transmission Control Module Replacement