Installation Procedure
WARNING: This page is about a different variant/trim than selected.
Install the engine control module (1) to the engine control module bracket (2).
Reposition the engine control module bracket (2) along with the engine control module.
- Connect the 3 engine control module electrical connectors (1) to the engine control module.
Install the engine control module bracket (1) along with the engine control module against arrow direction to the bracket and clip in the retaining clip (2).
Install the engine wiring harness (1) to the bracket.
- Clip in the 6 wiring harness clips (2, 3) to the bracket.
- Battery Negative Cable Disconnection and Connection - Connect
- Program the ECM. Control Module References