Removal Procedure
WARNING: This page is about a different variant/trim than selected.
- Battery Negative Cable Disconnection and Connection - Disconnect
Wiring Harness Clip (3) @ Engine Control Module Bracket - Unclip [3x]
- Wiring Harness Clip (2, 3) @ Engine Control Module and Electronic Brake Control Module Bracket - Unclip [3x]
- Engine Wiring Harness (1) - Position aside
Unclip the engine control module bracket (1) by unlocking the retainer (2).
- Remove the engine control module bracket (1) along with the engine control module in arrow direction from the engine control module and electronic brake control module bracket.
Engine Control Module Electrical Connector (1) @ Engine Control Module - Disconnect [3x]
- Remove the engine control module bracket (2) along with the engine control module.
Remove the engine control module bracket (2) from the engine control module (1) by unlocking the retaining clips.