Installation Procedure
WARNING: This page is about a different variant/trim than selected.
Engine Control Module Bracket (2) @ Engine Control Module (1) - Install
Reposition the engine control module bracket (2) along with the engine control module.
- Engine Control Module Electrical Connector (1) @ Engine Control Module - Connect [3x]
Install the engine control module bracket (1) along with the engine control module against arrow direction to the engine control module and electronic brake control module bracket and clip in the retaining clip (2).
Engine Wiring Harness (1) - Reposition
- Wiring Harness Clip (2, 3) @ Engine Control Module and Electronic Brake Control Module Bracket - Install [3x]
- Wiring Harness Clip (3) @ Engine Control Module Bracket - Install [3x]
- Battery Negative Cable Disconnection and Connection - Connect