Removal Procedure

WARNING: This page is about a different variant/trim than selected.

Before performing the first steps, review the Emission Reduction Fluid and Emission Reduction Fluid Handling .
Raise and support the vehicle. Lifting and Jacking the Vehicle
Courtesy of GENERAL MOTORS COMPANY

Clip (2) - Remove
Remove the emission reduction fluid shield door (1).
Fig 1: Identifying Emission Reduction Fluid Controller And Components
Courtesy of GENERAL MOTORS COMPANY

Disconnect the electrical connector:
1. Emission Reduction Fluid Controller (5)
2. Emission Reduction Fluid Exhaust Front Pipe Injector Supply Pipe Electrical Connector (2)
Wiring Harness (3) @ Wiring Harness Retainer (4) - Unclip
Emission Reduction Fluid Exhaust Front Pipe Injector Supply Pipe (1) - Disconnect
Close all open connections with the suitable closure plugs.
Emission Reduction Fluid Exhaust Front Pipe Injector Supply Pipe (1) @ Retainer (6, 7) - Unclip [2x]
Courtesy of GENERAL MOTORS COMPANY

Clip (2) - Remove [3x]
Emission Reduction Fluid Tank Shield (1) - Remove