Removal Procedure
WARNING: This page is about a different variant/trim than selected.
- Before performing the first steps, review the Emission Reduction Fluid and Emission Reduction Fluid Handling .
- Raise and support the vehicle. Lifting and Jacking the Vehicle
Clip (2) - Remove
- Remove the emission reduction fluid shield door (1).
Disconnect the electrical connector:
- Emission Reduction Fluid Controller (3)
- Emission Reduction Fluid Exhaust Front Pipe Injector Supply Pipe Electrical Connector (4)
- Wiring Harness (2) @ Wiring Harness Retainer (1) - Unclip
- Wiring Harness (2) - Position aside
- Emission Reduction Fluid Exhaust Front Pipe Injector Supply Pipe (6) @ Emission Reduction Fluid Supply Pump Module (5) - Disconnect
- Close all open connections with the suitable closure plugs.
Plastic Nut (1, 3) - Remove [4x]
- Emission Reduction Fluid Tank Shield (2) - Remove