Installation Procedure

WARNING: This page is about a different variant/trim than selected.

Courtesy of GENERAL MOTORS COMPANY

Emission Reduction Fluid Tank Shield (2) - Install
Plastic Nut (1, 3) - Install [4x]
Courtesy of GENERAL MOTORS COMPANY

Remove the closure plugs from all open connections.
Emission Reduction Fluid Exhaust Front Pipe Injector Supply Pipe (6) @ Emission Reduction Fluid Supply Pump Module (5) - Connect
Wiring Harness (2) @ Wiring Harness Retainer (1) - Install
Connect the electrical connector:
1. Emission Reduction Fluid Controller (3)
2. Emission Reduction Fluid Exhaust Front Pipe Injector Supply Pipe Electrical Connector (4)
Courtesy of GENERAL MOTORS COMPANY

Install the emission reduction fluid shield door (1).
Clip (2) - Install
Lower the vehicle.