Installation Procedure

WARNING: This page is about a different variant/trim than selected.

Courtesy of GENERAL MOTORS COMPANY

Emission Reduction Fluid Tank Pressure Sensor (2) - Install

CAUTION:

Emission Reduction Fluid Tank Pressure Sensor Bolt (1) - Install and tighten [2x] 2 N.m (18 lb in)
Courtesy of GENERAL MOTORS COMPANY

NOTE:
Install the cover by using the handling area indicated by the arrows.

Emission Reduction Fluid Supply Pump Module Cover (2) - Install
Emission Reduction Fluid Supply Pump Module Cover Bolt (1) - Install and tighten [6x] 2 N.m (18 lb in)
Emission Reduction Fluid Tank Shield - Install - Emission Reduction Fluid Tank Shield Replacement (Notchback) Emission Reduction Fluid Tank Shield Replacement (Hatchback)