Installation Procedure

WARNING: This page is about a different variant/trim than selected.

Emission Reduction Fluid Exhaust Front Pipe Injector Supply Pipe @ Vehicle - Install
Courtesy of GENERAL MOTORS COMPANY

Remove the closure plugs from all open connections.
Emission Reduction Fluid Exhaust Front Pipe Injector Supply Pipe (1) @ Emission Reduction Fluid Supply Pump Module (3) - Connect
Connect the electrical connector. (2)
Courtesy of GENERAL MOTORS COMPANY

Install the emission reduction fluid shield door (1).
Clip (2) - Install
Courtesy of GENERAL MOTORS COMPANY

Emission Reduction Fluid Exhaust Front Pipe Injector Supply Pipe (2) @ Clip (1) - Install [2x]
Courtesy of GENERAL MOTORS COMPANY

Clip (1) - Install [3x]
Courtesy of GENERAL MOTORS COMPANY

Emission Reduction Fluid Exhaust Front Pipe Injector Supply Pipe (1) @ Clip (2) - Install [3x]
Courtesy of GENERAL MOTORS COMPANY

Emission Reduction Fluid Exhaust Front Pipe Injector Supply Pipe (1) @ Retainer Clip (2) - Install [4x]
Courtesy of GENERAL MOTORS COMPANY

Clip (1) - Install
Courtesy of GENERAL MOTORS COMPANY

Remove the closure plugs from all open connections.
Emission Reduction Fluid Exhaust Front Pipe Injector Supply Pipe (1) - Connect - Plastic Collar Quick Connect Fitting Service
Fuel Tank - Install - Fuel Tank Replacement
Lower the vehicle.
Connect the battery negative cable. Battery Negative Cable Disconnection and Connection