Installation Procedure

WARNING: This page is about a different variant/trim than selected.

Courtesy of GENERAL MOTORS COMPANY

Emission Reduction Fluid Controller (2) - Install

CAUTION:

Emission Reduction Fluid Controller Bolt (3) - Install and tighten 5 N.m (44 lb in)
Connect the electrical connector. (1)
Courtesy of GENERAL MOTORS COMPANY

Emission Reduction Fluid Tank Shield (1) - Install
Clip (2) - Install [3x]
Fig 1: Identifying Emission Reduction Fluid Controller And Components
Courtesy of GENERAL MOTORS COMPANY

Emission Reduction Fluid Exhaust Front Pipe Injector Supply Pipe (1) @ Clip (6, 7) - Install [2x]
Remove the tightness tool from the emission reduction fluid exhaust front pipe injector supply pipe (1).
Emission Reduction Fluid Exhaust Front Pipe Injector Supply Pipe (1) - Connect
Wiring Harness (3) @ Clip (4) - Install
Connect the electrical connector:
1. Emission Reduction Fluid Controller (5)
2. Emission Reduction Fluid Exhaust Front Pipe Injector Supply Pipe Electrical Connector (2)
Courtesy of GENERAL MOTORS COMPANY

Install the emission reduction fluid shield door (1).
Clip (2) - Install
Lower the vehicle.
Connect the battery negative cable. Battery Negative Cable Disconnection and Connection
If replacing, reprogram the module. Control Module References