Removal Procedure

WARNING: This page is about a different variant/trim than selected.

Disconnect the battery negative cable. Battery Negative Cable Disconnection and Connection
Remove the front bumper fascia. Front Bumper Fascia Replacement
Charge Air Cooler Inlet Air Hose @ Charge Air Cooler - Remove - Charge Air Cooler Inlet Air Hose Replacement
Charge Air Cooler Outlet Air Hose @ Charge Air Cooler - Remove - Charge Air Cooler Outlet Air Hose Replacement
Courtesy of GENERAL MOTORS COMPANY

Disconnect the electrical connector. (1)
Courtesy of GENERAL MOTORS COMPANY

Engine Coolant Fan Shroud Bolt (1, 2) - Remove [2x]
Raise the vehicle.
Courtesy of GENERAL MOTORS COMPANY

Pull up the engine coolant fan shroud (1) until it can be put out of the 4 retaining tabs (2, 3).
Courtesy of GENERAL MOTORS COMPANY

Tilt the engine coolant fan shroud (1) as much as possible.
Retain the engine coolant fan shroud.
Courtesy of GENERAL MOTORS COMPANY

Disconnect the electrical connector. (1) [2x]
Charge Air Temperature Sensor (2) - Remove [2x]
Courtesy of GENERAL MOTORS COMPANY

NOTE:
A second technician is required.

Retainer Clip (1) - Unclip [2x]
Courtesy of GENERAL MOTORS COMPANY

Charge Air Cooler (2) @ Radiator Assembly (1) - Remove