Range Selector Lever Cable Adjustment
- Set the parking brake.
Pull the retaining collar (1) forward, then release the range select cable adjuster clip (2) by pushing out on the adjuster clip from the underneath.
- NOTE:
Adjust the automatic transmission range selector lever cable while the transmission and the transmission control are in the Park position only. Failure to do so may cause false adjustment.
Verify the range selector lever (1) is in the park position.
Rotate the lever counterclockwise till the stop (arrow).
- NOTE:
Adjust the automatic transmission range selector lever cable while the transmission and the transmission control are in the park position only. Failure to do so may cause false adjustment.
Verify the transmission control lever (1) is in the park position.
Depress the adjuster clip (2) locking the adjuster clip completely, then release the retaining collar (1).
- Ensure that the cable adjuster is secured.
- Check the transmission control lever in all gear selections for proper operation.
After installing the transmission range selector shift cable, pull up and push down on ALL connections to verify that the connections are fully seated and properly engaged. Failure to perform this task can result in the vehicle not being able to shift into PARK causing potential vehicle damage and bodily injury.