LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2018 >> Volt Premier >> Repair and Diagnosis >> Brakes >> Mechanical - Hydraulic >> Hydraulic Brakes >> Repair Instructions >> Brake Master Cylinder Reservoir Replacement >> Installation Procedure

Installation Procedure

  1. Brake Fluid Level Sensor Replacement  - Install
  2. GM4091186Courtesy of GENERAL MOTORS COMPANY

    Lubricate the brake master cylinder reservoir seals with GM approved brake fluid from a clean, sealed, brake fluid container. - Adhesives, Fluids, Lubricants, and Sealers 

  3. Brake Master Cylinder Reservoir Seal (2) @ Brake Master Cylinder (3) - Install [2x]
  4. Brake Master Cylinder Reservoir (1) @ Brake Master Cylinder - Install
  5. GM4091187Courtesy of GENERAL MOTORS COMPANY

    Brake Master Cylinder Reservoir Hose (2) - Connect

    6. CAUTION:

    Fastener Caution

  6. Bolt (3) @ Brake Master Cylinder Reservoir (1) - Install and tighten 2.5 N.m (22 lb in)
  7. GM4091185Courtesy of GENERAL MOTORS COMPANY

    Body Wiring Harness (1) @ Brake Master Cylinder Reservoir (3) - Install

  8. Clip (2) @ Brake Master Cylinder Reservoir - Install [2x]
  9. Clip (4) @ Brake Master Cylinder Reservoir - Install
  10. GM4084596Courtesy of GENERAL MOTORS COMPANY

    Electrical Connector (2) @ Brake Fluid Level Sensor (1) - Connect

  11. GM4084518Courtesy of GENERAL MOTORS COMPANY

    Install the radiator surge tank into the bracket and slide rearward to secure. (1)

  12. Clip (2) @ Radiator Surge Tank - Install
  13. Dash Upper Extension Panel Opening Cover Replacement - Install
  14. Bleed the brake system. Hydraulic Brake System Bleeding 
scientia non olet · About LEMON Manuals