Rear Side Door Trim Replacement

Callout	Component Name
1	Rear Side Door Inside Handle Bolt Cap Procedure Use a flat bladed plastic trim tool.
2	Rear Side Door Inside Handle Fastener CAUTION: Refer to Fastener Caution . Tighten 2.5 N.m (22 lb in)
3	Rear Side Door Armrest Pull Cup Bolt Cap Procedure Use a flat bladed plastic trim tool.
4	Rear Side Door Armrest Pull Cup Fastener [2x] Tighten 2.5 N.m (22 lb in)
5	Rear Side Door Trim Procedure Using the appropriate plastic trim tool loosen the retainers on the door trim panel. When the panel is sufficiently loosened, grasp with both hands and lift up and towards you to disengage integral retainers and clips. Disconnect the door lock retainer cable from the door trim panel and the inside handle. Disconnect the electrical connector. Place the door trim panel on a clean flat surface.