LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2018 >> Trax Premier, AWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 2 (Engine Controls And Fuel - 1.4L (LE2) - Repair Instructions) >> Repair Instructions >> Fuel Sender Assembly Replacement (AWD) >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2018 Buick Encore. However, it is still accessible from the selected car via links, so may be relevant.
  1. GM2772304

    Install a NEW fuel sender O-ring gasket (2) to the fuel sender (1).

  2. GM2772295

    Lower the fuel sender (1) into the fuel tank while connecting the fuel tank fuel pump module fuel pickup (2) to the fuel sender (1).

  3. GM2770636

    Install the fuel sender lock ring (1) to the fuel tank (2).

  4. Install the EN-48482  Fuel Sender Lock Ring Wrench to the fuel sender lock ring (1).
  5. Using the EN-48482  Fuel Sender Lock Ring Wrench and a long breaker-bar, rotate the fuel sender lock ring (1) in a clockwise direction in order to lock the lock ring.
  6. Connect the fuel tank sender wiring harness electrical connector.
  7. Install the fuel tank. Fuel Tank Replacement (FWD) Fuel Tank Replacement (AWD) 
scientia non olet · About LEMON Manuals