LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2018 >> Trax Premier, AWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 2 (Engine Controls And Fuel - 1.4L (LE2) - Repair Instructions) >> Repair Instructions >> Fuel Injector Wiring Harness Replacement >> Removal Procedure

Removal Procedure

WARNING: This page is about a different car, the 2018 Buick Encore. However, it is still accessible from the selected car via links, so may be relevant.
  1. Fuel Injection Fuel Rail Assembly - Remove - Fuel Injection Fuel Rail Assembly Replacement 
  2. GM3982086

    Disconnect the fuel injector wiring harness connector (1) from the fuel injection fuel rail fuel pressure sensor.

  3. Cut the fuel injector wiring harness tie strap (2) and DISCARD.
  4. Unclip the fuel injector wiring harness (3) from the fuel injection fuel rail.
  5. GM3982080

    Cut the remaining fuel injector wiring harness tie straps (1) and DISCARD.

  6. Disconnect the fuel injector wiring harness connectors (2) from the fuel injectors (3).
scientia non olet · About LEMON Manuals