LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2018 >> Trax Premier, AWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 16 (Engine Controls And Fuel - 1.4L (LE2) - Diagnostic Information And Procedures (P0010-P06B6)) >> Diagnostic Information and Procedures >> DTC P0201-P0204, P0261, P0262, P0264, P0265, P0267, P0268, P0270, P0271, P1248, P1249, P124A, P124B, P2147, P2148, P2150, P2151, P2153, P2154, P2156, or P2157 >> Circuit/System Verification

Circuit/System Verification

WARNING: This page is about a different car, the 2018 Buick Encore. However, it is still accessible from the selected car via links, so may be relevant.
  1. Ignition - On / Vehicle - In Service Mode
  2. Verify the scan tool parameter:
    • Cylinder 1 Injector Control Circuit Status = OK
    • Cylinder 2 Injector Control Circuit Status = OK
    • Cylinder 3 Injector Control Circuit Status = OK
    • Cylinder 4 Injector Control Circuit Status = OK
    • If not the specified state 

      Refer to: Circuit/System Testing

    • Go to next step: If the specified state 
  3. Operate the vehicle within the Conditions for Running the DTC. You may also operate the vehicle within the conditions that you observed from the Freeze Frame/Failure Records data.
  4. Verify the DTC does not set.
    • If the DTC sets 

      Refer to: Circuit/System Testing

    • Go to next step: If the DTC is not set 
  5. All OK.