Conditions for Running the DTC

P0030, P0031, P0032, P0036, P0037, P0038

• Engine Speed = Greater than 400 RPM
• Ignition Voltage = 11 to 32 V

Frequency the DTC runs = Continuously - After the running conditions are met - For greater than 5 s

P0053, P0054

• DTCs related to the following system/component = Not Set
  • B34 Engine Coolant Temperature Sensor
  • B111B Turbocharger Boost/Intake Air Temperature Sensor
• ECT Sensor & IAT Sensor = Within 8°C (14°F) of each other
• ECT Sensor = 30 to 255°C (86 to 491°F)
• Engine = Running
• Ignition Voltage = Less than 32 V

Frequency the DTC runs = Once - Per cold start-up - After the running conditions are met

P0135, P0141

• DTC P0116, P0117, P0118, P0119, P0128, P111E = Not set
• HO2S Heater = Device controls are not active.
• HO2S 1, 2 Heater Command = Greater than 0% Duty Cycle
• Ignition Voltage = 10 to 32 V

Frequency the DTC runs=2 times - Per drive cycle - After the running conditions are met - For greater than 120 s

P103B, P103C

• Engine = CrankingorRunning
• Ignition Voltage = 10 to 32 V

Frequency the DTC runs = Continuously - After the running conditions are met - For greater than 3 s