LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2018 >> Trax Premier, AWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 10 (Engine Controls And Fuel - 1.4L (LE2) - Diagnostic Information And Procedures (P0325-P2635) And Symptoms) >> Diagnostic Information and Procedures >> DTC P163A >> Component Testing

Component Testing

WARNING: This page is about a different car, the 2018 Buick Encore. However, it is still accessible from the selected car via links, so may be relevant.

Static Test

  1. Ignition OFF, disconnect the harness connector at the G18 High Pressure Fuel Pump.
    2. NOTE:

    The DMM and test leads must be calibrated to 0 Ω in order to prevent misdiagnosis.

  2. Test for 1.09 - 1.21 Ω at 20°C (68°F) between the high control circuit terminal 2 and the low control circuit terminal 1.
    • If not between 1.09 - 1.21 Ω 

      Replace the G18 High Pressure Fuel Pump.

    • Go to next step: If between 1.09 - 1.21 Ω 
  3. Test for infinite resistance between each terminal and the G18 High Pressure Fuel Pump housing.
    • If less than infinite resistance 

      Replace the G18 High Pressure Fuel Pump.

    • Go to next step: If infinite resistance 
  4. All OK
scientia non olet · About LEMON Manuals