LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2018 >> Trax Premier, AWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 10 (Engine Controls And Fuel - 1.4L (LE2) - Diagnostic Information And Procedures (P0325-P2635) And Symptoms) >> Diagnostic Information and Procedures >> DTC P0601-P0604, P0606, P062B, P062F, P0630, P16F3, or P262B >> Circuit/System Verification

Circuit/System Verification

WARNING: This page is about a different car, the 2018 Buick Encore. However, it is still accessible from the selected car via links, so may be relevant.
  1. Ignition On.
  2. Verify DTC P0602 or P0630 is not set.
    • If any of the DTCs are set 
    1. Program the K20 Engine Control Module. Refer to Control Module References .
    2. Verify DTC P0602 or P0630 is not set.
      • If any of the DTCs are set, replace the K20 Engine Control Module.
      • Go to next step: If none of the DTCs are set
    3. All OK.
    • Go to next step: If none of the DTCs are set 
  3. Verify DTC P0601, P0603, P0604, P0606, P062B, P062F, P16F3, or P262B is not set.
    • If any of the DTCs are set 

      Replace the K20 Engine Control Module.

    • Go to next step: If none of the DTCs are set 
  4. All OK.