LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2018 >> Trax Premier, AWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 10 (Engine Controls And Fuel - 1.4L (LE2) - Diagnostic Information And Procedures (P0325-P2635) And Symptoms) >> Diagnostic Information and Procedures >> DTC P0443, P0458, or P0459 >> Component Testing

Component Testing

WARNING: This page is about a different car, the 2018 Buick Encore. However, it is still accessible from the selected car via links, so may be relevant.

Static Test

  1. Ignition OFF, disconnect the harness connector at the Q12 Evaporative Emission Purge Solenoid Valve.
  2. Test for 10-30 Ω between the control terminal 2/B and the ignition circuit terminal 1/A.
    • If not between 10-30 Ω 

      Replace the Q12 Evaporative Emission Purge Solenoid Valve.

    • Go to next step: If between 10-30 Ω 
  3. All OK.

Dynamic Test

  1. Ignition OFF, disconnect the harness connector at the Q12 Evaporative Emission Purge Solenoid Valve.
  2. Install a 3 A fused jumper wire between the ignition terminal 1/A and 12 V. Install a jumper wire between the control terminal 2/B and ground.
  3. Verify the Evaporative Emission Purge Solenoid Valve turns on & off/clicks and flows vacuum.
    • If it does not turn on & off/click or flow vacuum 

      Replace the Q12 Evaporative Emission Purge Solenoid Valve.

    • Go to next step: If it does turn on & off/clicks and flows vacuum 
  4. All OK
scientia non olet · About LEMON Manuals