LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2018 >> Trax Premier, AWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 1 (Engine Mechanical - 1.4L (LE2)) >> Repair Instructions - On Vehicle >> Timing Chain Tensioner Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2018 Buick Encore. However, it is still accessible from the selected car via links, so may be relevant.
  1. GM3977663

    Timing Chain Tensioner Shoe(2) - Install

  2. Timing Chain Tensioner Shoe Bolt(1) - Install and tighten 25 N.m (18 lb ft)
  3. GM3689090

    Install a NEW gasket.(2)

  4. Timing Chain Tensioner(1) - Install
    5. CAUTION:

    Refer to Fastener Caution .

  5. Timing Chain Tensioner Bolt(4) - Install and tighten 25 N.m (18 lb ft)[2x].
  6. Remove the suitable tool (3) from the timing chain tensioner.
  7. GM4091100

    Remove the EN-51367  holder (1).

  8. Timing Chain Upper Guide Replacement  - Install
  9. Check the position of the crankshaft, camshaft and camshaft position actuator adjuster.
    1. TEMPORARILY install the engine front cover with 4 bolts and the crankshaft balancer.
    2. GM3682494

      Turn crankshaft 720 degrees in the direction of engine rotation by the crankshaft balancer bolt (3).

  10. GM4091100
    NOTE:

    If the EN-51367  holder (1) can be installed, the engine timing is properly adjusted. If the EN-51367  holder (1) can not be installed, confirm the engine is set to cylinder 1 top dead center (TDC) of combustion stroke.

    Install the EN-51367  holder (1).

  11. Remove the EN-51367  holder.
  12. Remove the TEMPORARILY installed engine front cover and crankshaft balancer.
  13. Engine Front Cover Replacement  - Install
    14. NOTE:

    Right Side

  14. Front Wheelhouse Liner Replacement (Chevrolet)Front Wheelhouse Liner Replacement (Buick) - Install
  15. Camshaft Cover Replacement  - Install
scientia non olet · About LEMON Manuals