LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2018 >> Trax Premier, AWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 1 (Engine Mechanical - 1.4L (LE2)) >> Repair Instructions - On Vehicle >> Intake Camshaft Replacement >> Removal Procedure

Removal Procedure

WARNING: This page is about a different car, the 2018 Buick Encore. However, it is still accessible from the selected car via links, so may be relevant.
  1. Camshaft Position Actuator Replacement  - Remove
  2. GM3982573
    NOTE:

    Many internal engine components will develop specific wear patterns on their friction surfaces. Components MUST be separated, marked, or organized in a way to ensure installation to their original location and position. Take precautions in order to prevent interchanging of parts.

    Tag or mark each part immediately when removed. Indicate location, direction, or orientation when necessary.

  3. Loosen the 12 camshaft bearing cap bolts (1) 1/2 turn working from outside to inside in spiral steps.
    4. NOTE:

    Observe the markings on the bearing caps. Ensure that each bearing cap is marked in order to identify its location and direction.

  4. Remove the camshaft bearing cap bolts.(1)[12x]
  5. Remove the camshaft bearing caps.(2)[6x]
  6. Remove the intake camshaft.(3)
scientia non olet · About LEMON Manuals