LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2018 >> Trax Premier, AWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 1 (Engine Mechanical - 1.4L (LE2)) >> Repair Instructions - On Vehicle >> Exhaust Camshaft Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2018 Buick Encore. However, it is still accessible from the selected car via links, so may be relevant.
  1. GM3981907

    Coat the exhaust camshaft with engine oil. Adhesives, Fluids, Lubricants, and Sealers 

    2. NOTE:

    Ensure that the camshaft notch at the front of the camshaft indicated by arrow is in the 12 O ' clock position before installing the camshaft caps.

  2. Install the exhaust camshaft (3) in the cylinder head.
  3. Prior to installing the camshaft bearing caps, rotate the oil seal in the groove of the number one camshaft journal so that the split line is approximately at the 12 O ' clock position as indicated by the arrow.
    4. NOTE:

    Ensure the caps are installed in the original location and position.

  4. Lubricate the camshaft bearing caps (2) and the bolts (1) with clean engine oil. Adhesives, Fluids, Lubricants, and Sealers 
  5. Install the camshaft bearing caps.(2)[6x]
  6. Hand start the 12 camshaft bearing cap bolts (1).
  7. GM3982069
    CAUTION:

    Refer to Fastener Caution .

    Tighten the bearing cap bolts (1) in sequence three turns each until the caps are seated.

  8. Tighten the bearing cap bolts in sequence as shown to 12 N.m (106 lb in).
  9. Camshaft Position Actuator - Install - Camshaft Position Actuator Replacement 
scientia non olet · About LEMON Manuals