LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2018 >> Trax Premier, AWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 1 (Engine Mechanical - 1.4L (LE2)) >> Repair Instructions - On Vehicle >> Crankshaft Front Oil Seal Replacement >> Removal Procedure

Removal Procedure

WARNING: This page is about a different car, the 2018 Buick Encore. However, it is still accessible from the selected car via links, so may be relevant.
  1. Crankshaft Balancer Replacement  - Remove
  2. GM3686999
    NOTE:

    The engine can be equipped with two different front oil seal designs.

    Check the seal to confirm which crankshaft front oil seal (1, 2) is installed.

  3. GM3686993

    Install the DT-6125-B  hammer (2) to DT-23129  seal remover (3).

  4. Install the DT-2165-B  hammer with the DT-23129  seal remover behind the crankshaft front oil seal (1).
  5. Remove the crankshaft front oil seal (1), with the DT-6125-B  hammer (2).
scientia non olet · About LEMON Manuals