LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2018 >> Trax Premier, AWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 1 (Engine Mechanical - 1.4L (LE2)) >> Repair Instructions - Off Vehicle >> Piston, Connecting Rod, and Bearing Cleaning and Inspection >> Connecting Rod Visual Inspection Procedure

Connecting Rod Visual Inspection Procedure

WARNING: This page is about a different car, the 2018 Buick Encore. However, it is still accessible from the selected car via links, so may be relevant.
  1. GM233855

    Inspect the piston pin bushing (4) for scoring or damage.

  2. Inspect the connecting rod beam (1) for twisting or bending.
  3. Inspect the rod cap (2) for any nicks or damage caused by possible interference.
  4. Inspect for scratches or abrasion on the rod bearing seating surface.
    5. NOTE:

    DO NOT scrape the rod or rod cap.

  5. If the connecting rod bores contain minor scratches or abrasions, clean the bores in a circular direction with a light emery paper. Thoroughly clean the parts and perform a high-pressure wash if an abrasive is used on the bores.
scientia non olet · About LEMON Manuals