LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2018 >> Trax Premier, AWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 1 (Engine Mechanical - 1.4L (LE2)) >> Repair Instructions - Off Vehicle >> Cylinder Head Cleaning and Inspection >> Camshaft Cap Bore Alignment

Camshaft Cap Bore Alignment

WARNING: This page is about a different car, the 2018 Buick Encore. However, it is still accessible from the selected car via links, so may be relevant.
  1. Ensure the camshafts are serviceable. Refer to Camshaft Cleaning and Inspection .
  2. Inspect the cylinder head camshaft bore surfaces for any imperfections or scratches that could inhibit proper camshaft clearances.
  3. Install the camshafts in the cylinder head.
  4. Install the camshaft bearing caps.
  5. Install the camshaft cap bolts and tighten to 10 N.m (89 lb in).
  6. Ensure the camshafts spin freely in the cylinder head. If the camshaft does not turn freely, the cylinder head must be replaced.
scientia non olet · About LEMON Manuals