LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2018 >> Trax Premier, AWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 1 (Engine Mechanical - 1.4L (LE2)) >> Repair Instructions - Off Vehicle >> Automatic Transmission Flex Plate Installation

Automatic Transmission Flex Plate Installation

WARNING: This page is about a different car, the 2018 Buick Encore. However, it is still accessible from the selected car via links, so may be relevant.
GM3600400
Callout Component Name
1 Crankshaft Position Sensor Reluctor Ring
CAUTION:

Refer to Crankshaft Position Sensor Reluctor Ring Caution .
2 Automatic Transmission Flex Plate

Procedure

  1. Install the flex plate, and install the flex plate bolts hand tight to hold in place.
  2. Install EN-51760  holder to lock the flywheel via the starter ring gear.

Special Tools 
EN-51760  Flywheel Holder
For equivalent regional tools, refer to Special Tools .
3 Automatic Transmission Flex Plate Bolt (Qty: 8)
CAUTION:

Refer to Fastener Caution .

CAUTION:

Refer to Torque-to-Yield Fastener Caution .

NOTE:

Bolts have adhesive patch and must be tightened to final torque within 5 minutes.


Procedure 
Tighten the NEW flex plate bolts in the sequence shown.
  1. Tighten the bolts a first pass to 20 N.m (15 lb ft).
  2. Tighten the bolts a second pass to 30 N.m (22 lb ft).
  3. Using the EN-45059  angle meter, tighten the bolt a final pass 70 degrees.
  4. Remove EN-51760  holder once final torque is achieved.

Special Tools 
EN-45059  Angle Meter
For equivalent regional tools, refer to Special Tools .
scientia non olet · About LEMON Manuals