LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2018 >> Trax Premier, AWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 1 (Engine Mechanical - 1.4L (LE2)) >> Diagnostic Information and Procedures >> Oil Pressure Diagnosis and Testing >> Procedure

Oil Pressure Diagnosis and Testing: Procedure

WARNING: This page is about a different car, the 2018 Buick Encore. However, it is still accessible from the selected car via links, so may be relevant.
  1. GM3657733

    Remove the engine oil pressure sensor (1).

  2. GM3657734

    Install the EN-21867-850  adapter (1).

  3. Install the CH-48027  gauge (2).
  4. Start the engine.
  5. Check oil pressure.
  6. At idling speed, the oil pressure must be greater than 180 kPa (26.11 psi) and the oil temperature must be 85°C (185°F) or more.
  7. Remove the CH-48027  gauge (2).
  8. Remove the EN-21867-850  adapter (1).
  9. Turn off the engine.
  10. GM3657733

    Install the engine oil pressure sensor (1).

  11. Tighten the sensor to 35 N.m (26 lb ft).
  12. Check the engine oil level.
scientia non olet · About LEMON Manuals