LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2018 >> Trax LT, AWD >> Repair and Diagnosis >> Heating, Ventilation & A/C (HVAC) >> HVAC Control Systems >> HVAC System - Automatic >> Repair Instructions >> Heater and Air Conditioning Remote Control Replacement

Heater and Air Conditioning Remote Control Replacement

GM4407145
Callout Component Name

Preliminary Procedures

  1. Disconnect the battery negative cable. Battery Negative Cable Disconnection and Connection (without KL9)Battery Negative Cable Disconnection and Connection (with KL9)
  2. Heater and Air Conditioning User Interface Control Replacement 
1 Heater and Air Conditioning Remote Control
NOTE:

When reconnecting the heater and air conditioning remote module, the BROWN J2 connector must be connected last. Once all the parts are all in place, check and clear all DTCs in the heater and air conditioning remote control.

Procedure

  1. Un-latch the heater and air conditioning remote control from the Instrument panel and maneuver out from Instrument panel.
  2. Connect the battery negative cable. Battery Negative Cable Disconnection and Connection (without KL9)Battery Negative Cable Disconnection and Connection (with KL9)
  3. Perform the necessary programming and setup procedure:Control Module References
  4. Clear the DTCs from the heater and air conditioning remote control module.
  5. Perform the actuator calibration procedure. Actuator Recalibration 
scientia non olet · About LEMON Manuals