LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2018 >> Trax LT, AWD >> Repair and Diagnosis (Single Page) >> Accessories & Equipment >> Exterior Lights >> Lighting System - Repair Instructions >> Repair Instructions >> Rear License Plate Lamp Wiring Harness Replacement

Rear License Plate Lamp Wiring Harness Replacement

GM2844444
Callout Component Name

Preliminary Procedure

  1. Remove the liftgate lower trim finish panel. Refer to Liftgate Lower Trim Finish Panel Replacement
  2. Remove the rear center applique. Refer to Liftgate Center Applique Replacement (Chevrolet)Liftgate Center Applique Replacement (Buick) .
  3. Disconnect the electrical connector.
1 Rear License Plate Lamp Wiring Harness

Procedure

  1. Disconnect the electrical harness from the applique.
  2. Disconnect the electrical harness from the rearview camera image display module.
  3. Replace the license plate bulbs if needed.
scientia non olet · About LEMON Manuals