Front Seat Belt Retractor Replacement

Callout	Component Name
WARNING: Refer to SIR Warning . WARNING: Refer to SIR Inflator Module Handling and Storage Warning . WARNING: In order to prevent accidental deployment and the risk of personal injury, do not dispose of an undeployed inflatable restraint seat belt pretensioner as normal shop waste. Undeployed seat belt pretensioners contain substances that could cause severe illness or personal injury if their sealed containers are damaged during disposal. Use the following deployment procedures to safely dispose of an undeployed seat belt pretensioner. Failure to observe the following disposal methods may be a violation of appropriate country, regional or local laws. Preliminary Procedures Disable the SIR system. SIR Disabling and Enabling Center Pillar Lower Trim Panel Replacement Loosen the front seat belt from front seat belt anchor plate tensioner. Refer to Front Seat Belt Anchor Plate Tensioner Replacement .
1	Front Seat Belt Retractor Bolt - Lower CAUTION: Refer to:Fastener Caution . Tighten 45 N.m (33 lb ft)
2	Front Seat Belt Retractor Bolt - Upper Tighten 9 N.m (80 lb in)
3	Front Seat Belt Retractor Guide Retainer Procedure Use a flat bladed plastic tool to remove.
4	Front Seat Belt Retractor D Ring Bolt Tighten 45 N.m (33 lb ft)
5	Front Seat Belt Retractor Procedure Disconnect the electrical connector. Pretensioner Handling and Scrapping Enable the SIR System. SIR Disabling and Enabling