Circuit/System Description

The brake pedal position sensor is used to sense the action of the driver application of the brake pedal. The brake pedal position sensor provides an analog voltage signal that will increase as the brake pedal is applied. The body control module (BCM) provides a low reference signal and a 5 V reference voltage to the brake pedal position sensor. When the variable signal reaches a voltage threshold indicating the brakes have been applied, the BCM will apply battery voltage to the center high mounted stop lamp control circuit illuminating the center high mounted stop lamp. The R44 Radio Antenna Signal Filter Module eliminates unwanted electrical noise/interference emitted through the radio antenna signal when the Center High Mounted Stop Lamp is illuminated